 |
 |
|
|
I had an idea this morning! I thought I would do a Twitter jewellery tutorial. As you know Twitter allows just 140 characters per tweet, so my tutorial is in 10 easy Tweets and I used Twitpic to show the images. Here are the 10 steps…
1/10: Goggles on, mark 70mm onto silver wire, cut with the saw - gently does it and no pressure.
2/10: Prop silver against block, light gas torch, anneal (heat to dull red)
3/10: Quench in water, put in 'pickle'(weak acid) to remove oxide. Rinse in water and dry.
4/10: Use pliers to bend silver into a circle, ends must over lap.
5/10: Check it is the correct size, cut through both end with saw.
6/10: Use pliers to make ends meet smoothly and tightly.
7/10: Put ring on heat block, paint with flux, cut solder, place on join. Heat with torch.
8/10: File away excess solder, buff with sandpaper until join disappears.
9/10: Hammer on mandrel to make ring round and flat, and finally polish. Finished!
10/10: The finished ring!
I am a contemporary jewellery designer maker based in rural Herefordshire. My collection is subtle and pure incorporating clean lines and a soft finish. I pass on my skills through teaching jewellery workshops from my jewellery making studio. All designs are handmade.
